How to use Summa F-Series Cutters?

How to use Summa F-Series Cutters?

Problem/Question
How to use Summa F-Series Cutters?

Solution/Work-Around
To use the Summa F-Series Cutters, you should follow the normal Ergosoft procedure for cutting.
It just need special attention regarding the Driver mode you want to use.
Please, see below the different options available.
  1. Summa F-Series - Standard driver
  2. Summa F-Series POSTNET- Use the POSTNET barcode
When using Summa F-Series and Postnet drivers, the option for "Cutting Tool" can be select from a default list.
  1. Summa F-Series Go Produce - Use the GoProduce software
For the Summa F-Series GoProduce, the "Cutting Tool" list needs to be loaded.
To load such a list into your system, you need to upload the "Material List" into your Cut Environment.
Please follow the steps below:
  1. Select your Cut Environment
  2. Open the Cut Settings
  3. Select the "Device Options" tab
  4. Select "Use Material XML"
  5. "Setup" and "Browse" for the file
  6. Click "OK"
  7. Now a list should be visible in your Cut Environment
  8. Click "OK" to close and save the Cut Environment
Now when opening the "Cutting Tool" tab, you should be able to select the Media and Method.

    • Related Articles

    • Cut Driver not licensed / License count exceeded when trying to start Summa Cut Environment

      Problem/Question When attempting to select an existing Cut Environment for a Summa Cutter or to start the CutQueue for a Summa, Ergosoft RIP displays an error message "Cut Driver not licensed" or "License count exceeded". The most common source of ...

    • How to setup Summa S & Summa S2 Class plotters (from 16.4)

      Problem/Question After an update the Summa plotter works not as intended. You are confused about the variations of available drivers and need to know which driver to choose. Solution/Work-Around Just choose the type as described below: DRAG_HEAD ...

    • Cut button grayed out / not available

      Problem/Question ContourCut is licensed, but the “Cut” button in the software is grayed out and cannot be used. Solution/Work-Around “Contour Cut” has to be activated Within JobComposer select "View" (top menu) Open "Tools" Check "Cut Environments" ...

    • Mimaki CJV150 Cut Only

      Problem/Question Cut Only job is moved to the Done section after dispatch but the device is not moving - not cut has been done. Caused by the variety of different USB driver provided by Mimaki, somtimes cut only on the CJV150 does not work properly. ...

    • About the Cut Workspace

      This video explains how to activate the contour cut features in the Ergosfot RIP and how to switch to the dedicated Cut Workspace: https://youtu.be/iNt_AAWBNOk