Hide the Splash Screen

• Related Articles

• Error 0xc0000005 when starting an application of Ergosoft

  Problem/Question When trying to run an application of Ergosoft kind of the following error message appears: “The application was unable to start correctly (0xc0000005)" Error Code 0xc0000005 could be caused by several reasons in a Windows PC like ...

• Ergosoft cannot be started after Windows 11 Preview Update KB5074105

  Problem/Question After installing the Windows 11 Preview Update KB5074105, systems using PC-Bound licenses may experience startup failures. In affected cases, Ergosoft ControlCenter does not start, and Windows reports an application crash in the ...

• Cut Driver not licensed / License count exceeded when trying to start Summa Cut Environment

  Problem/Question When attempting to select an existing Cut Environment for a Summa Cutter or to start the CutQueue for a Summa, Ergosoft RIP displays an error message "Cut Driver not licensed" or "License count exceeded". The most common source of ...

• Networked Department Start order (Waiting for Ergosoft communication)

  Problem/Question The following messages may appear when starting a Network Department Client. If this message does not disappear in seconds/minutes, the Client can't connect to the Master. (A permanent network connection between all Networked ...

• Jobs Stuck on "Waiting to RIP" – No RIP Engine Running

  Applies to: Ergosoft RIP 2025 and later Use this when: Jobs remain in “Waiting to RIP” status and do not start processing You send a job to RIP & Print but nothing happens The RIP process does not start automatically Problem / Question A job is sent ...