Related Articles
Cut button grayed out / not available
Problem/Question ContourCut is licensed, but the “Cut” button in the software is grayed out and cannot be used. Solution/Work-Around “Contour Cut” has to be activated Within JobComposer select "View" (top menu) Open "Tools" Check "Cut Environments" ...
Cut Driver not licensed / License count exceeded when trying to start Summa Cut Environment
Problem/Question When attempting to select an existing Cut Environment for a Summa Cutter or to start the CutQueue for a Summa, Ergosoft RIP displays an error message "Cut Driver not licensed" or "License count exceeded". The most common source of ...
Mimaki CJV150 Cut Only
Problem/Question Cut Only job is moved to the Done section after dispatch but the device is not moving - not cut has been done. Caused by the variety of different USB driver provided by Mimaki, somtimes cut only on the CJV150 does not work properly. ...
How to implement Print & Cut Devices
Problem/Question For Print and Cut devices, usually up to 3 different Cut drivers (Cut after, Using Marks and Cut only) can be selected. "Where can I find the individual Cut drivers and how to add them?" Solution/Work-Around Select the Print ...
Print or Cut Environment outputs PPL file instead of desired PRN, PRT, Cut file
Problem/Question When printing with a Print Environment or Cut Environment that uses a file interface (E.g. Zuend), the driver will output a .ppl file instead of the required file type like .prn, prt, .cut, etc. The .ppl file is an Ergosoft internal ...